detherth
Member
- Joined
- May 5, 2013
- Messages
- 42
- Reaction score
- 0
- Points
- 6
- Location
- Buffalo New York
- Vehicle Year
- 1997
- Make / Model
- Ford Ranger
- Engine Size
- 4.0L V6
- Transmission
- Manual
I was wondering if anyone had any clue why when i took apart my 1986 ford ranger 4X4, it didn't have any thrust bearings or "toothed washers/spacers"
It does have warn manual locking hubs but in all my research to put it back together everyone says to install the toothed washer back on. Does it have to be put back on or would it be fine without?
Thanks any help is appreciated.
It does have warn manual locking hubs but in all my research to put it back together everyone says to install the toothed washer back on. Does it have to be put back on or would it be fine without?
Thanks any help is appreciated.