PurpleRane94
New Member
- Joined
- Feb 9, 2013
- Messages
- 19
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 1994
- Make / Model
- Ford
- Engine Size
- 4.0
- Transmission
- Manual
ok almost done here. pick the block up tommorow frm the machine shop and putn it together this weekend. everythings just about ready as its gona be but the transfer case situation. Iv been doin as much research as I can but havnt found my answers. whats the best case to use? I want to be able to use the stock speedo cable hookup and hav it as close as possible to stock case length. if all possible I want to avoid driveshaft mods. but if I do is it best to use f150 shafts? and if I use my shafts, what do I need to make it mate to the case properly. again its goin in a 94 extended cab with 4.0 5spd. all suggestions will be greatly appreciated.