SlipknotBren
New Member
- Joined
- Mar 1, 2016
- Messages
- 11
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 1987
- Make / Model
- Ford
- Transmission
- Manual
I swapped a 93 explorer 4.0 into a 87 bronco 2 I am using my gen 1 dash and just the explorer engine harness... I cannot for the life of me get this thing to fire I have a new icm crank shaft position sensor is given 1 volt ac current when turning over, new coil and plugs/wires but it will NOT Spark!!! I have the big yellow wire (which I believe to be main ignition) spliced together.. I have red/lt green to red/ lt green spliced and I have black and orange to yellow/lt blue. I'm losing my mind over this.. Is there another wire I'm supposed to have spliced? I it's my daily driver and it being under the knife isn't helping me any ha ... I've searched for hours but can't find my answer I'm new to forums and don't really know how to do all this but if anyone could help me in anyway that would be a life saver thanks. I posted the pic of the guide I found and have been using if that could help
Attachments
-
83.6 KB Views: 185
-
172.8 KB Views: 194