Welcome Visitor! Please take a few seconds and 
Ditchbanger
New Member
- Joined
- Sep 24, 2011
- Messages
- 91
- Reaction score
- 0
- Points
- 0
- Location
- Maine
- Vehicle Year
- 1993
- Make / Model
- Ford
- Engine Size
- 3.0
- Transmission
- Manual
Heres my info: Just put in a new 3.0 with 120k on it. Took the clutch off my motor I pulled because it was new when I bought the truck last year. I was recently driving it I had about 80 miles on the new motor. I stopped at a stop light and held my clutch for a bit and it got noisy and was vibrating a little. This happened whether I was holding it in gear or not. It would stop if i pulled it out of gear and pushed my clutch or just let off and push it down again before putting it in gear. It only does it if i hold my clutch for a while. I am wondering if it is air in my lines or if it is my slave cylinder? I am going to bleed it now and let you guys know if it changes.
