- Joined
- Sep 22, 2007
- Messages
- 12,631
- Reaction score
- 7,769
- Points
- 113
- Location
- Michigan
- Vehicle Year
- 1987
- Make / Model
- Ford
- Engine Type
- 2.9 V6
- Engine Size
- 177 CID
- Transmission
- Manual
- 2WD / 4WD
- 2WD
- My credo
- A legend to the old man, a hero to the child...
Not to change the subject but what do you guys think about this for bracing the corner?
Its for granite countertops....ill also run the angle iron under it and use washers to make everything even, obviously ill be using it in an L shape not the shape the pic shows it postioned) It dont have a weight rating (that i can find) but its 1/2 in thick and goes plenty deep enough to get the front of the bracket up into good steel (about 12 inches...these go up to 16)
Its for granite countertops....ill also run the angle iron under it and use washers to make everything even, obviously ill be using it in an L shape not the shape the pic shows it postioned) It dont have a weight rating (that i can find) but its 1/2 in thick and goes plenty deep enough to get the front of the bracket up into good steel (about 12 inches...these go up to 16)