• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Any negative effects on ditectly dumping the exhaust


rededge02

New Member
Joined
Oct 17, 2007
Messages
20
Reaction score
0
Points
0
Vehicle Year
2002
Make / Model
ranger
Transmission
Automatic
Are there any negative side effects if you dump your exhaust directly (ie:no tail pipe)
 


Hahnsb2

New Member
TRS Banner 2010-2011
Joined
Aug 8, 2007
Messages
4,416
Reaction score
36
Points
0
Age
35
Location
Battle Ground WA
Vehicle Year
88-95
Make / Model
Ford-Dodge
Engine Size
4.0-5.2 Turbo
Transmission
Manual
Exhaust gases are corrosive so it will "eat" the underside of your truck over time.
 

Gabe8810

Member
Joined
Oct 16, 2007
Messages
373
Reaction score
0
Points
16
Location
Albuquerque, New Mexico
Vehicle Year
1996
Make / Model
Ranger
Engine Size
4.0
Transmission
Manual
i dumped my exhaust but at the same time i rhino sprayed the under side of my bed and frame and its been like that for two years and its been fine
 

ZMan

Forum Staff Member
TRS Forum Moderator
MTOTM Winner
TRS Event Participant
Joined
Jan 5, 2003
Messages
3,778
Reaction score
406
Points
83
Age
38
Location
Medina, Ohio
Vehicle Year
1992,1994
Make / Model
Ford Rangers
Engine Type
4.0 V6
Transmission
Manual
2WD / 4WD
2WD
Total Drop
4/4, bagged
can't say my exhaust caused my bed to rot out any more than the road salt did. I dumped my exhaust the same time I put new shocks on. Drove it for a year and a half and the shocks don't have a spot of rust on them, the passenger shock is right there at the end of the muffler!
 

Wicked_Sludge

New Member
Joined
Aug 6, 2007
Messages
6,937
Reaction score
43
Points
0
Age
38
Location
Westport, WA
Vehicle Year
1993
Make / Model
Ford
Engine Size
3-point-GO
Transmission
Manual
the shocks are also painted, whereas the frame and crossmembers are bare steel.

dumping also increases the risk of trapping a "bubble" of CO2 under the body of the truck and allowing it to seep into the cab....nobody likes to be dead.

why not just buy a $3 90-degree bend and make it stick out before the rear tire?
 

1987 DANGER RANGER

New Member
Joined
Oct 15, 2007
Messages
118
Reaction score
0
Points
0
Age
40
Location
Great Bend Kansas
Vehicle Year
1987
Make / Model
Ford
Transmission
Manual
I've got a 99 dakota and my exhaust dumps off right before the rear axle. Its a flow master with a 90deg welded right to the muffler. Its about 5yrs old no problems not rot not rust. During the winter when its friggen cold the exhaust steam will freeze to the rear axle.
 

ZMan

Forum Staff Member
TRS Forum Moderator
MTOTM Winner
TRS Event Participant
Joined
Jan 5, 2003
Messages
3,778
Reaction score
406
Points
83
Age
38
Location
Medina, Ohio
Vehicle Year
1992,1994
Make / Model
Ford Rangers
Engine Type
4.0 V6
Transmission
Manual
2WD / 4WD
2WD
Total Drop
4/4, bagged
the shocks are also painted, whereas the frame and crossmembers are bare steel.

dumping also increases the risk of trapping a "bubble" of CO2 under the body of the truck and allowing it to seep into the cab....nobody likes to be dead.

why not just buy a $3 90-degree bend and make it stick out before the rear tire?
the frame and crossmember are not bare steel, unless it was already rusted to begin with, which yes mine are, but I'm not contributing it to my exhaust. I couldn't have it exit in front of my rear tire because I have the muffler in the stock location, and it ends too far back to exit in front of the tire. Can't put it any farther forward because of my carrier bearing crossmember.

And since its so dangerous, do you have any statistics of how many people have died because of a dumped exhaust?

Its NOT that big of a deal.
 

Wicked_Sludge

New Member
Joined
Aug 6, 2007
Messages
6,937
Reaction score
43
Points
0
Age
38
Location
Westport, WA
Vehicle Year
1993
Make / Model
Ford
Engine Size
3-point-GO
Transmission
Manual
i never said dumping your exhaust would lead to immediate death...i said it increases the risk which is a fact that you cannot deny...and its therfor worth bringing up.

and that crappy thin paint ford applies to the undersides of their pickups doesnt stand up to even regular road use, much less corrosive gas. even the paint on the underside of my bed is still intact...wheras the frame is down to bare metal with a few straggling peices of black here and there.
 

mkpecor

New Member
Joined
Dec 27, 2007
Messages
1,020
Reaction score
1
Points
0
Age
41
Location
black diamond W.A.
Vehicle Year
1988
Make / Model
ranger 4x4
Engine Size
2.9
Transmission
Manual
i cut mine off 10" be hind the cats, never get any gases in the cab not even at stop lights with windows down, sounds pretty good to peaple always ask me if i have flow masters, i say i have no flows on here, need to get it fixed some time, if any thing put an angled tip on it so the shit goes to the ground and not all over your spare tire like mine does.
 

spdcrazy

New Member
Joined
Mar 8, 2008
Messages
1,007
Reaction score
2
Points
0
Age
36
Location
Homer, alaska
Vehicle Year
mostly 86
Make / Model
B2
Engine Size
2.9 bored and cammed
Transmission
Manual
i got a cammed 2.9 in my b2, with straight exhaust. spent 70 bucks and had a shop cut it and weld a single piece without mufflers and whatnot. dumps out ont he right side b4 the rear axle. looks great. sounds like i got a 302 in there. and when i get off the gas at mid RPMs... it makes sounds that most dont expect from a lil 2.9
 

Sponsored Ad


Sponsored Ad

Staff online

Today's birthdays

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Shran
April Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top