Need OBD-II Trouble Code input

[Jim Oaks]

I'm working on a page for trouble codes:

http://www.therangerstation.com/tech_library/OBD-II_codes.html

I'd like to list common trouble codes that Ranger owners may experience. If you've had a problem with a trouble code, please post it below along with the remedy so we can share it with others.

Thanks.

 

[BRUTUS_T_HOG]

p0171: was a bad fuel injector also causing a dead misfire

p0400-p0404: DPFE sensor almost everytime lol

p1000: sets after codes are erased or battery is disconnected

p1051: you have to push the brake pedal down during KOER test, if not this code will set or the brake circuit has a problem

p1404: usually only on california vehicles, i've had a couple that the temp sensor was completely covered in carbon or the EGR passages were plugged

p0551: power steering switch had fluid leaking into the connector, replace switch.

thats all i feel like remembering right now lol, i just went down the list to see if i've dealt with any

 

[a31ford]

Hey Jim (Assuming you have e-mail notification on this thread).

I have found the "GOD" Book (Sorry if this is over the top), it's an 85 Mb. PDF on Ford injection and computers,

Some 442 pages !!!!!!!

Because of it's size I would have to put it up on my web server so you could download it.

It's got "everything, about everything"...................

Let me know.

Greg Manning,
Brandon, Mb, Canada

 

[alwaysFlOoReD]

^^^Would this be appropriate info for the backyard mechanic trying to learn obdII ?
If so, would you be willing to let me copy it?
Thanks,

Richard

 

[Destroyer000]

p01443, purge valve code.. almost everytime its the sensor or the solenoid... always be sure to check your pins i have seen them get the green disease

 

[Sasquatch_Ryda]

Got it.

Sent from my SGH-I747M using Tapatalk 2

 

[Sheppard Honor]

The PCM monitors voltage drop to determine coolant temperature. If the ECT reads less than freezing temp. when engine has been running for more than a few minutes, the PCM determines a circuit fault and sets this code. Or if the PCM determines the sensor resistance is out of specs, this code is set.

 

[SirSantie]

So my truck is throwing up P0153, P0174, P0133 and last but not least P1152. Any suggestions as to where I can start?