Mike's '93 4x4

[MountainMike]

Thanks Nate, I'm really surprised at how much trimming is involved. But shouldn't be a big deal.

 

[Sasquatch_Ryda]

I just ground the rivets off and removed the entire crossmember.

 

[-Nathan-]

I left that bit of the member because there is a skid attached to it for the front of the gas tank.

 

[Sasquatch_Ryda]

Huh...not on my 91. Good ta know.

 

[MountainMike]

Check out what came today!

This is why I need to get the truck plated ASAP.

 

[MountainMike]

Huh...not on my 91. Good ta know.

That is good to know, now I almost know what I'm doing before I do it!

 

[Sasquatch_Ryda]

Almost.....now that you're a Premium member I guess we can tell you all the little secrets

 

[MountainMike]

Almost.....now that you're a Premium member I guess we can tell you all the little secrets

I'm glad I've been accepted into such an exclusive club.

 

[Sasquatch_Ryda]

Let the hazing begin!

 

[Ranger Sport Honduras]

nice plates Mike!

 

[Andres629]

Digging the level iii thing, but get it color matched IMO. Sweet plates too, did the truck pass safety?

Sorry for the thread jack, but Sasquatch, would you feel like selling one of those one piece driveshafts?

 

[IndianScout]

Mike owning a `93 I'm watching this thread like a hawk..

very nice so far...

 

[-Nathan-]

just get in there and do it Mike I want WHEELING pics STAT.

 

[MountainMike]

Let the hazing begin!

Noooooooooo!

Digging the level iii thing, but get it color matched IMO. Sweet plates too, did the truck pass safety?

I'd be going with OEM ones, just with an extra I stuck on. I haven't gotten my safety "officially" done yet. When I was getting the front end stuff I got a pre-safety safety. I now have a fix-it list and once that's done I should be golden.

Mike owning a `93 I'm watching this thread like a hawk..

very nice so far...

Thanks you sir, keep checking in!

just get in there and do it Mike I want WHEELING pics STAT.

Yes sir!

 

[gwaii]

jeez...i turn around for a minute and you got 5 more pages going.

lookin good,i like the plates.

where do you get the ones that say 'yukon' on the bottom like that?

i've run into the same rubbing problem on the one piece shaft before-my solution was similar to nathans,just trimmed the hell out of the tank skid.