• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

LS Swapped Ranger


LS Ranger

Active Member
Joined
Feb 2, 2017
Messages
25
Vehicle Year
1997
Transmission
Automatic
1997 Ranger started out as 2.3l 5spd.
Now has 5.3l (lm7) from 2002 Silverado & 4l60e trans.
Truck is lowered with DJM Dream Beams and flip kit in the rear (3/4)drop.
15x7 wheel & 235/60/15 tire (front).
15x8 wheel & 255/60/15 tire BFG or 27x10x15 Hoosiers (rear).
Ford 8.8'' rear end 4.10 gear & spool.
I have a lot more pictures but can't get them to upload onto this site.

84916-cleaned-ready-hurt-feelings.jpg

84858-cleaned-car.jpg
84096-a.jpg
84095-a.jpg
84648-headers-nice-burnt-bronze.jpg
84652-pcm-fuse-relay-panel-air-bag-cover.jpg
84671-transmission-temp-water-temp-oil-pressure.jpg
84670-air-filter.jpg
84645-trans-cooler-fuel-cell-battery-kill-switch.jpg
 
>>>>

NICE! Just curious as to where do your headers/exhaust exit?
 
Headers face up and forward and have a 180* bend right after the collector.
The exhaust goes on the outside of the frame into two 18'' Magnaflow Magnapak mufflers and exit right in front of the rear tires.
I have a lot of pics from this build but can't seem to upload the pics here.
 
whoa, now that is something. Did you swap any parts on the motor or use it as-is from the truck?
 
whoa, now that is something. Did you swap any parts on the motor or use it as-is from the truck?
The only thing I changed on the motor was mounts and headers. I have a BTR Stage 4 Truck cam Specs are 224/230 .553/.547 111+2 and a 3400 RPM stall convertor sitting in the garage but I'm not gonna put it in until spring.
 
smart money.:icon_thumby::icon_thumby::icon_thumby:

I think there are more gm powered v8 rangers in wayne county then fords...







I would pull air from the cowl....but I have to drive in water...
 
>>>>>>>>>>

Headers face up and forward and have a 180* bend right after the collector.
The exhaust goes on the outside of the frame into two 18'' Magnaflow Magnapak mufflers and exit right in front of the rear tires.
I have a lot of pics from this build but can't seem to upload the pics here.
==================
Best thing to do is find a program that lets you change the pixels to 1000 or less, then go to IMGUR.com and upload them there to be posted here.

GL
 
More Pictures there is gonna be a lot of them.










































 
Very nice job! Have you got a time slip yet?

No not yet the only thing I've taken the truck to was a local 1/4mi radar run.
The truck ran 104mph five times in a row. I'm guessing it'll run 13s it doesn't hook very good.
 
very nice swap, I will be doing this with my 87. i'll be switching to carb and using a turbo 400 trans. Is the 8.8 out of an explorer? also do you have any other pics of the motor mounts?
 
I don't have any better pics of the mounts, and the 8.8 came from a 02 ranger 4x4.
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top