LS swap! finally

[Bird76Mojo]

Jealous of you finding that service bed. I've been looking for one for ages now for my 2001 Ranger.

 

[Mackhedq]

Jealous of you finding that service bed. I've been looking for one for ages now for my 2001 Ranger.

Just keep looking. Found this one in background of a photo on marketplace. Apparently was on an S10

 

[ryan]

Running! With oil pressure and a working transmission. Waiting on a transfer case seal and its time to drive

You piece together that intake or is it all one? Debating how I want to do mine since I need to put the MAT sensor in it.

 

[rubydist]

Just keep looking. Found this one in background of a photo on marketplace. Apparently was on an S10

Then we are also grateful that you saved the service body from further embarrassment by getting it off the bowtie.

 

[Mackhedq]

You piece together that intake or is it all one? Debating how I want to do mine since I need to put the MAT sensor in it.

3" or 4" aluminum (I can't remember)and a matching rubber coupling with a built in maf sensor location.

 

[Mackhedq]

Drained 16 gallons of 2.5 year old gas. Stuff was nasty. Hopefully it runs better after fresh

 

[bobbywalter]

short cycle some cleaner with a seperate container to clean the system and injectors

 

[socal_Redranger]

How much did the engine end up weighing I looked around and I saw that a 6.0 like yours weighs about the same as a new Godzilla somewhere around 540 dressed.

 

[Mackhedq]

How much did the engine end up weighing I looked around and I saw that a 6.0 like yours weighs about the same as a new Godzilla somewhere around 540 dressed.

I'm not sure how much the motor is but I think its less than stock. Entire truck weights 4600lb 55/45 split

 

[socal_Redranger]

I'm not sure how much the motor is but I think its less than stock. Entire truck weights 4600lb 55/45 split

oh okay, well it looked like it fit pretty good even with the huge 6l80.