Welcome Visitor! Please take a few seconds and 
austinrick
Well-Known Member
- Joined
- Feb 19, 2009
- Messages
- 46
- Vehicle Year
- 1993
- Transmission
- Automatic
Just had my a/c replaced after five Texas summers without it! Man, what a pleasure!
Well, I have discovered that, though the blower motor is blowing fine, it seems a little weak through the dash vents. When I reached down to the floor vent where heat comes out in cold weather, I feel too much a/c coming out--enough to rob some cold air from up top.
Looking at my Haynes manual, it looks like this model ('93) has cable control to a lever and cam actuating the 'floor/defrost' door.
Is this correct, and can I tighten up that door by going through the glove compartment to the cables and adjusting the draw?
Still trucking at 323,000 miles (same 3.0L.... same everything but tranny)!
Well, I have discovered that, though the blower motor is blowing fine, it seems a little weak through the dash vents. When I reached down to the floor vent where heat comes out in cold weather, I feel too much a/c coming out--enough to rob some cold air from up top.
Looking at my Haynes manual, it looks like this model ('93) has cable control to a lever and cam actuating the 'floor/defrost' door.
Is this correct, and can I tighten up that door by going through the glove compartment to the cables and adjusting the draw?
Still trucking at 323,000 miles (same 3.0L.... same everything but tranny)!
