302/t5 swap with hydraulic clutch

[mopar_66757]

Hi I got my 302 in my ranger, turned out the automatic tranny was junk so I decided to get a T5 5speed. I was able to get a t5 for $150 and found a brand new 7.25" mini-clutch for $350.
Now my question is what's the easiest/cheapest way to make it a hydraulic clutch instead of cable?
Thanks

 

[frogman]

Not saying this is the way, but I am looking at this for my car. Maybe the info there will help you too. http://midnightdsigns.com/Mustang/HYD Clutch.htm

 

[RangerSVT]

Research teddyzee build, he did an easy, inexpensive, off the shelf parts for his clutch setup...


SVT

 

[mopar_66757]

thanks, I ended up using the stock master cyl. and got a pull type slave cyl. from speedway.com for 35bucks. The line I went from the stock plastic line to a 5/16'' compression to a 3/16'' inverted flare and used steel line to go to the slave.
It works great, just a little hard to push than a stock, but I got under a 100 in it.