2.9L Crank But No Start After Starter Replacement

[ty.forestcom]

50/50 test. If it wont start or try with ether or gas, then it's electrical. Check your spark. Check your timing.

What should my procedure be for timing? I’ve got good spark

 

[alwaysFlOoReD]

Honestly i don't think its timing, but iirc, pull the spout and put a timing light on it. Should be 10 degrees btdc.
With all the work you've done, maybe a connector didn't seat properly. I had that happen to me. Took 2 months off and on before i figured it out,

 

[ty.forestcom]

Honestly i don't think its timing, but iirc, pull the spout and put a timing light on it. Should be 10 degrees btdc.
With all the work you've done, maybe a connector didn't seat properly. I had that happen to me. Took 2 months off and on before i figured it out,

To be honest I haven’t made it that far on my journey yet. I can read my chilton though. Thank you

 

[ty.forestcom]

Honestly i don't think its timing, but iirc, pull the spout and put a timing light on it. Should be 10 degrees btdc.
With all the work you've done, maybe a connector didn't seat properly. I had that happen to me. Took 2 months off and on before i figured it out,

Any idea what the connector could be? Or just meaning in general? Thx

 

[alwaysFlOoReD]

In general, but would most likely be one that had something to do with ignition.