fuel pump

Hey everybody, I've got a quick question - my inertia switch crapped out on my 1988 ranger the other day and I've been trying to find a replacement. It's proving a more difficult than I anticipated, and it doesn't look like there are any OE parts available at all. does anyone have...

We’ve replaced the fuel pump twice and still aren’t getting it to kick on, we’ve tested the relay, inertia switch, and checked voltage at fuel pump connection and voltage seems to be good. Any other reason the fuel pump wouldn’t kick on even if it’s getting power??

So I’m replacing the fuel pump on my 99 3.0 V6 flex fuel. I noticed on my original fuel pump there is an extra filter, but on the new pump I just bought it’s not there. Is this filter necessary? If so where can I find a new one? Any help is greatly appreciated!

I have a 1988 ford ranger, 2.9L V6 with a dual tank system. Right now the gauge somewhat works but its as if there is a gray zone berween the 1/4 and 3/4 fill lines that the gauge cant go over/under. When we tried testing the ground on the pump we found that it may be a grounding issue since the...

I have a 2004 ford ranger 3.0 v6 with 210k miles. I drove to work and the truck was perfectly fine I turn the truck off and when I go to leave it won’t start just cranks. I assume fuel pump because it didn’t turn on with a jump and when I sprayed starter fluid in it started. I took the bed off...

1989 bronco II. I just rebuilt and installed the original 2.9. While attempting the initial startup and break in I got code 95 "fuel pump circuit open – EEC processor to motor ground". I haven't been able to find anything specific on how to fix this issue or problems it would cause. Any help...

BLUF: In-tank low pressure fuel pump/ sending unit caused no acceleration beyond light touch on the gas. Figured I’d post here because I’ve seen a few threads with no final updates of 2.9l owners having identical issues, but disappearing without a final update (perhaps after having fixed… or...

Hey all! So my truck (1991 4.0 XLT 5 speed manual) was reliable when it was warmer out, it would start up every time just fine. as it got colder, around 30 degrees the fuel pump would prime intermittently, sometimes it would prime sometimes it wouldn't, and I'd have a crank, no start. I...

the fuel pump is definitely on its way out right now on my ranger and i’ve heard reports that certain after market pumps are not very good, if y’all have done this before which one should i get ? i usually go through rock auto but if i need to go somewhere else that’s fine would really like some...

Hey everyone, I hate to say but I've been having a lot of issues with my truck truck stalling intermittently for the past couple of months. It stalls when parked and when driving and there's no telling when it's going to happen again. I recently pulled codes and it seems like codes 95 and 87...

Hi i just joined this forum and I'm looking for help or advice with my bronco. I just got it about a month ago and about a week ago the engine light turned on. It was revving really high in park and there was strong gas fumes. I got it towed to a car place that was recommended by a coworker and...

Hello TRS! New member here. I have a 1991 4.0 v6 ranger XLT and have no power to my fuel pump. The only source of power I have is 4 volts that I figure is the fuel gauge. I have replaced the 30A fuse, the fuel relay switch, and have bypassed the inerta switch;(all 3 have proper power according...

Ok guys here’s my issue, driving the bronco today and she died on me. turned the key and got a battery light, my abs light, no check engine light and fuel pump wouldn’t prime. Let it sit for a minutes and boom it came on, surged and sputtered then died. Tried again about 5 minutes later and it...

Hey all, I've got a 1993 Ranger 4.0 V6 4x4 that has been giving me some issues. Long story short, it started sputtering and losing power about 6 months ago, so it sat for a while as we can function with just one car in our house, luckily. During this time I changed the oil, spark plugs & wires...

86 2.3l will crank but not fire. I bought this truck from a guy that states "the fuel pump relay went out" replaced the relay and it still wont fire. I have jumped the inertia switch for GP. Here is my current status: Ignition on: no fuel pump prime. however, 12v power applied directly to the...

I own three Rangers, and have had to drop the fuel tanks in two. (that was enough!) For any future pump/sender replacement, from inside the bed, located the area where the unit is located, and carefully cut out an access hole to R&R without removing tank or bed. Went to junkyard and cut out a...

Hey Guys, I have a 2002 Ranger Edge 3.0L gas with 121k miles. A few months ago, it would occasionally crank but not start after being driven for a while (maybe 5+ miles). After sitting for about a day, it would then start right up. Now, it'll crank but not start at all, even when cold. When it...

I have been chatting with user Mark_88 and he has been very helpful but he suggested I also put a summary of the problems I am still having here on this forum so here it is. A problem I was initially having lead to a no start problem. The no start problem is resolved but the initial problem is...

My 88 ranger is no longer starting, ill try to keep this short. I don't really have any mechanic experience so please bear with me. A few months ago it began having problems starting. It would turn over but not start, but if i kept trying then after a few minutes it would, sometimes it would...

Hey all. I just replaced the fuel tank, pump and sending unit on my 1990 Bronco ii and can't seem to get it running again. Before replacing the tank and all that I did a full tune-up and replaced the map sensor and tps. I made sure everything was square and the truck was running well before...