• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

No spark


Barbara

Member
Joined
Sep 9, 2020
Messages
36
Reaction score
6
Points
8
Location
Michigan
Vehicle Year
1985
Make / Model
Ford ranger
Transmission
Manual
Hi everyone, so I got the lower rear thermostat housing taking care of, no leaks. The truck was sitting for about 3 weeks, ran fine when I parked it. Went to start it, battery was dead. Bought a new battery and it cranks really slow and no spark from any of the spark plugs. Replaced the coul, cap and rotor, plug wires and coil wire, still no spark. It's a 1985 ranger v6 2.8 with a duraspark. Only other thing I can think of is getting a new ignition module, any ideas? Thank you appreciate it. I've been without a vehicle for almost a month.
 


gaz

Well-Known Member
U.S. Military - Veteran
Joined
Sep 21, 2007
Messages
1,420
Reaction score
656
Points
113
Location
Wa, Bremerton 98310
Vehicle Year
1987
Make / Model
Ford
Engine Size
87Ranger Endrigo 2.9l, 87BII Endrigo 4.0l
2WD / 4WD
4WD
Total Lift
Ranger 5" (2" suspension), BII 4" suspension
Total Drop
Ranger 5sp, BII A4LD
Tire Size
Ranger 33"/4:10LS, BII 29"/3:73LS
My credo
Deengineer until it is how Blue Oval should have sold it!!
Hello,

I would verify that the coil has a voltage output first. Then determine whether it is low or if it's consistent.
 

Sponsored Ad


Sponsored Ad

Staff online

Members online

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Shran
April Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top