chiloh30
New Member
- Joined
- Jun 24, 2009
- Messages
- 23
- Reaction score
- 0
- Points
- 0
- Location
- Tucson, Arizona
- Vehicle Year
- 1999
- Make / Model
- Ford
- Engine Size
- 3.0 FFV
- Transmission
- Automatic
..Hey, hope this is the right place for this,,,I have a '99 ranger 4x4. am working on ball joints and have a querry.
When I get to the passenger side ball joint, this is a 2 piece control arm (upper), and can only find the outer piece (part with ball joint), do i have to remove and replace the bushings in the passenger side upper control arm myself/or shop?? I also was wondering, do you have any articles on the rebuilding of the front hubs, bearings/seals, etc,,this truck has vucum hubs converted to Rugid Ridge.
(I consider myself a good backyard mech, been doing this for years , I do appriciate all the tech here)
When I get to the passenger side ball joint, this is a 2 piece control arm (upper), and can only find the outer piece (part with ball joint), do i have to remove and replace the bushings in the passenger side upper control arm myself/or shop?? I also was wondering, do you have any articles on the rebuilding of the front hubs, bearings/seals, etc,,this truck has vucum hubs converted to Rugid Ridge.
(I consider myself a good backyard mech, been doing this for years , I do appriciate all the tech here)