• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

35's and stock gears


Hooligan2c

New Member
Law Enforcement
Joined
Apr 2, 2012
Messages
252
Reaction score
2
Points
0
Location
Tobyhanna PA
Vehicle Year
2001
Make / Model
Ford
Engine Size
4.0 SOHC
Transmission
Automatic
I have heard 2 different sides to this one on other forums. So I am asking this forum the same question. I have stock 4:10 gears, limited slip rear. Can I run 35" tires on these gears without shredding them. I was talking to a buddy of mine today about running 35's with the stock gears and he said it would not shred a thing. I have heard the opposite from other people saying 35's would kill them.

So what is the right answer? I know that if I upgrade gears, that is the safe bet. But just normal driving on 35's with stock gears? Will it hurt anything?
 


nb11

Member
Joined
Sep 4, 2010
Messages
389
Reaction score
10
Points
18
Location
South Georgia
Vehicle Year
2003
Make / Model
Ford
Engine Size
2.3l
Transmission
Manual
It won't shred the gears, no. But it'll put a huge load on the transmission. If you have a manual, you'll be hard on the clutch. If you have an auto, it'll be hard on the torque converter and will likely always be looking for the right gear on the highway. I wouldn't think it would be a very pleasant experience.
 

Hooligan2c

New Member
Law Enforcement
Joined
Apr 2, 2012
Messages
252
Reaction score
2
Points
0
Location
Tobyhanna PA
Vehicle Year
2001
Make / Model
Ford
Engine Size
4.0 SOHC
Transmission
Automatic
Ok, I have an automatic. Will tuning it help anything?
 

nb11

Member
Joined
Sep 4, 2010
Messages
389
Reaction score
10
Points
18
Location
South Georgia
Vehicle Year
2003
Make / Model
Ford
Engine Size
2.3l
Transmission
Manual
I really don't know. I just know that running those tires on those gears would put a strain on the transmission. According to the "gears needed after tire change" calculator in the tech library, and assuming your original tires were approximately 31's, running 35's with 4.10 gears would give an actual ratio of 3.63:1, which is less-than-desirable.
 

06RangerXLT

New Member
Joined
Jul 24, 2010
Messages
2,876
Reaction score
54
Points
0
Location
Georgetown Ontario
Vehicle Year
2006
Make / Model
Ford
Engine Size
4.0L
Transmission
Automatic
you want 4.56+. why? power. you can burn your trans up quick if you try to use the wrong gears. now 4.10's wont KILL it, but it wont be a rocket off the line. Go for it man.
 

Sunk

New Member
Supporting Member
TRS Banner 2010-2011
TRS Banner 2012-2015
Joined
Aug 19, 2007
Messages
6,657
Reaction score
125
Points
0
Age
35
Location
Everett, WA
Vehicle Year
2012
Make / Model
Ford
Engine Size
3.5 Eco
Transmission
Automatic
Can you? Yes. Do you want to? Probably not.
 

Sasquatch_Ryda

Well-Known Member
Ford Technician
OTOTM Winner
Solid Axle Swap
Forum Staff - Retired
TRS Banner 2012-2015
Joined
Aug 8, 2007
Messages
7,916
Reaction score
108
Points
63
Age
36
Location
Terrace, BC, Canada
Vehicle Year
1991
Make / Model
Ford
Engine Type
4.0 V6
Engine Size
4.0L
Transmission
Automatic
2WD / 4WD
Solid Axle Swap 4x4
Tire Size
40s
I ran 35's with 3.55's for over a year....was it ideal...hell no. Did it work? Yeup.
 

Hooligan2c

New Member
Law Enforcement
Joined
Apr 2, 2012
Messages
252
Reaction score
2
Points
0
Location
Tobyhanna PA
Vehicle Year
2001
Make / Model
Ford
Engine Size
4.0 SOHC
Transmission
Automatic
Thanks guys, I appreciate the input. Right now I am running 33's for 3 years and the truck seems great with them. My buddy has 35's that are pretty much new and I can get them dirt cheap. I'll give it a shot and re-gear once I saved up the dough. Thanks again guys, any more input is greatly appreciated as well!
 

cdawall

New Member
U.S. Military - Active
Solid Axle Swap
Joined
Jan 29, 2010
Messages
549
Reaction score
5
Points
0
Location
Ellsworth AFB
Vehicle Year
2005
Make / Model
Ford
Engine Size
4.0L V6
Transmission
Automatic
It is no different than running 33's with 3.73's and plenty of people do that combo. I didn't like 33's and stock 4.10's went to 4.88's right off the bat. I now have 5.38's and 38's :) I wouldn't personally run 35's and 4.10's, but it will work.
 

RangerSVT

Oct 09 OTOTM
Article Contributor
V8 Engine Swap
OTOTM Winner
Solid Axle Swap
RBV's on Boost
ASE Certified Tech
TRS Banner 2010-2011
TRS Banner 2012-2015
Joined
Mar 15, 2009
Messages
7,883
Reaction score
53
Points
48
Location
TRS since 2002 - NW KY
Vehicle Year
19962002
Make / Model
Ford
Engine Size
GT-40 5.0L EFI W/AC
Transmission
Automatic
I've ran my stock 327s with 35s, 4.0 ohv 5r55e auto. Only got about 10-12 mpg, but it wasn't bad. The 4.0 has quite a bit of torque to get it moving. I went to 456s and my mpg went up to 17s, along with easier takeoff...

SVT
 

kryptonitecb

New Member
U.S. Military - Veteran
Joined
Dec 5, 2011
Messages
1,313
Reaction score
19
Points
0
Location
Fort Worth, TX
Vehicle Year
1994
Make / Model
Ford
Engine Size
4.0
Transmission
Manual
I'm running 37" with 4.10 and yes highway driving sucks. Tops out at 75mph but it's do able. I would recommend a higher number gear if you can afford it.

Sent from road while ignoring traffic
 

Hooligan2c

New Member
Law Enforcement
Joined
Apr 2, 2012
Messages
252
Reaction score
2
Points
0
Location
Tobyhanna PA
Vehicle Year
2001
Make / Model
Ford
Engine Size
4.0 SOHC
Transmission
Automatic
Great, thanks alot for the input guys!
 

RangerBoy94

Active Member
Joined
Mar 6, 2011
Messages
1,403
Reaction score
24
Points
38
Location
Northern California
Vehicle Year
1968
Make / Model
Ford
Engine Size
360CDI
Transmission
Automatic
Do it it aint gonna kill your truck
 

Hooligan2c

New Member
Law Enforcement
Joined
Apr 2, 2012
Messages
252
Reaction score
2
Points
0
Location
Tobyhanna PA
Vehicle Year
2001
Make / Model
Ford
Engine Size
4.0 SOHC
Transmission
Automatic
I think I just might!!
 

Vexy

Member
Firefighter
Joined
Oct 31, 2010
Messages
391
Reaction score
2
Points
18
Location
Wolcott, CT
Vehicle Year
1996
Make / Model
Mazda
Engine Size
4.0
Transmission
Manual
It puts unnecessary load on your drivetrain, lowers your overall mpg, messes up your speedo calibration+mileage counter, and takes away any grunt your truck may have had with stock tires. A proper regear will do wonders.
 

Sponsored Ad


Sponsored Ad

Staff online

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Shran
April Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top