Welcome Visitor! Please take a few seconds and - Joined
- Aug 13, 2011
- Messages
- 83
- Reaction score
- 11
- Points
- 8
- Location
- Calhoun,GA
- Vehicle Year
- 1999
- Make / Model
- Ford
- Engine Size
- 4.0
- Transmission
- Automatic
- 2WD / 4WD
- Solid Axle Swap 4x4
- Total Lift
- ??????
- Tire Size
- 39X12.50R17
- My credo
- I'm not afraid of dying, not living terrifies me!
I drive a 1999 Ranger XLT standard cab, 4X4, 4.0, AT. What I am trying to find is what size(ie: 1310,1330,etc) Front and Rear U-joints it has 
. The reason is that I am gathering parts to swap in Super Duty axles 
and I would love to retain the same u-joints throughout. I can buy new flanges for the SD axles I just need to know what size and I am trying to have as many parts on hand before tear-down as possible. Pretty sure custom driveshafts are going to be needed and if I have to change sizes no biggie.
One of the HUGE goals of this project is parts simplicity, being able to walk into a parts store and ask for a '99 Ranger U-joint is a lot easier than asking for a 1330-1350 conversion joint.
Thanks in advance for your help!
. The reason is that I am gathering parts to swap in Super Duty axles and I would love to retain the same u-joints throughout. I can buy new flanges for the SD axles I just need to know what size and I am trying to have as many parts on hand before tear-down as possible. Pretty sure custom driveshafts are going to be needed and if I have to change sizes no biggie. One of the HUGE goals of this project is parts simplicity, being able to walk into a parts store and ask for a '99 Ranger U-joint is a lot easier than asking for a 1330-1350 conversion joint.
Thanks in advance for your help!
