SRD
Member
- Joined
- Jun 18, 2021
- Messages
- 56
- Reaction score
- 14
- Points
- 8
- Location
- Las Vegas
- Vehicle Year
- 1999
- Make / Model
- Ford Ranger XLT
- Engine Type
- 3.0 V6
- Transmission
- Automatic
- 2WD / 4WD
- 2WD
Hello. I have a 1999 Ford Ranger XLT 2wd Truck.
I went to start the truck and the key turns but nothing happens. Never starts. went inside the house came back out and it just stopped working.
The dash board "Theft" light was flashing fast with key in ignition. I waited 45-60 Seconds and it flashed "1" time followed by "3" fast flashes.
"13 No Key/no PATS key has been used to turn the ignition switch." I think is the proper code but not sure how to properly tell.
Looking for a way to diagnose and repair. I have a programmed key and got new ignition a while back and truck has been working fine past 2 years....
Any direction would help. I am NOT a mechanic....just a private owner looking to fix his issues.
Thanks.
I went to start the truck and the key turns but nothing happens. Never starts. went inside the house came back out and it just stopped working.
The dash board "Theft" light was flashing fast with key in ignition. I waited 45-60 Seconds and it flashed "1" time followed by "3" fast flashes.
"13 No Key/no PATS key has been used to turn the ignition switch." I think is the proper code but not sure how to properly tell.
Looking for a way to diagnose and repair. I have a programmed key and got new ignition a while back and truck has been working fine past 2 years....
Any direction would help. I am NOT a mechanic....just a private owner looking to fix his issues.
Thanks.