BudgetB3000
Member
- Joined
- Jul 4, 2018
- Messages
- 42
- Reaction score
- 0
- Points
- 6
- Location
- Pullman, WA
- Vehicle Year
- 1998
- Make / Model
- Mazda
- Transmission
- Manual
I'm currently doing a clutch job on my truck and I cannot remove this god damned flywheel. I've been spraying the bolts down daily and taking a breaker bar to them but its virtually impossible to do since the flywheel spins freely. Normally I would just put a second breaker bar on the front of the crankshaft but on the 3.0 engine there is not enough clearance with the engine in the car to do so. Any suggestions on how to get this done?