grimcoyote
New Member
- Joined
- Dec 28, 2010
- Messages
- 2
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 1999
- Make / Model
- Ford
- Transmission
- Automatic
Ok Everyone. I'm new to the site, but have been reading a lot of the threads and posts. I have learned a great deal from everyone here but I'm still having problems with my heat. Here's the deal... Heat blows cold on a '99 Ranger 2wd 3.0L 6 cylinder.
What I've done:
Checked blend door and actuator*(sp?): good
Check and flush heater core: good
Check flow gate and vacume: good
Flushed system: good
Replace Thermostat: good
Bleed air from system (many times): good
Checked flow to and from heater core: good
Replace radiator cap: good
The overflow tank is always bubbling and filling up after it warms up, even after the new thermostat and radiator cap. And, yes, I am using a straight 50/50 mix of Prestone.
Everything done and it still doesn't blow hot but maybe a very little every now and then. Please oh please help. Been working on this problem for a week and I'm going insane. AND, it's freakin cold outside lol. Thanks much
What I've done:
Checked blend door and actuator*(sp?): good
Check and flush heater core: good
Check flow gate and vacume: good
Flushed system: good
Replace Thermostat: good
Bleed air from system (many times): good
Checked flow to and from heater core: good
Replace radiator cap: good
The overflow tank is always bubbling and filling up after it warms up, even after the new thermostat and radiator cap. And, yes, I am using a straight 50/50 mix of Prestone.
Everything done and it still doesn't blow hot but maybe a very little every now and then. Please oh please help. Been working on this problem for a week and I'm going insane. AND, it's freakin cold outside lol. Thanks much