Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Hmm, that's a good idea! Does anyone know if the engine cross members are the same on the TTB rangers like my 91, compared to torsion bar Rangers/Explorers though??
They are not exactly the same frame though. Can anyone 100% verify using complete unmodded sploder 5.0L mounts in a 91 style ttb setup? Because they are not even mentioned in the tech article for my generation truck v8 swap.. RangerSVT used just the plates of the sploder mounts in his ttb ranger... "I used the stock rubber 4.0L mounts and the explorer plates. The locator tabs on the rubber mounts were removed. The passenger side fit without any mods needed. The driver side did need trimming and one hole drilled." - RangerSVT.
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
