fastpakr
Forum Staff Member
TRS Event Staff
TRS Forum Moderator
Supporting Member
Article Contributor
U.S. Military - Veteran
V8 Engine Swap
TRS 20th Anniversary
TRS Event Participant
- Joined
- Aug 6, 2007
- Messages
- 8,025
- Reaction score
- 2,841
- Points
- 113
- Location
- Roanoke, VA
- Vehicle Year
- 1999
- Make / Model
- Ford
- Engine Type
- V8
- Engine Size
- 5.0
- Transmission
- Automatic
- 2WD / 4WD
- 4WD
- Tire Size
- 285/75-16
I'm looking for a way to mount a telephone microphone that looks OEM. Ideally, I'd like to find a simple vent cover or very small flush mount tweeter that can be clipped into a hole drilled in the plastic of an overhead console.
Here's a picture of the console:
The microphone is very small, maybe 3/8" wide or so. Any suggestions on a simple way to hide it? BMW uses something like this:
I don't need something anywhere near that size. Just a round cover like a flush mounted tweeter, only a lot smaller. Would love to hear some suggestions.
Here's a picture of the console:
The microphone is very small, maybe 3/8" wide or so. Any suggestions on a simple way to hide it? BMW uses something like this:
I don't need something anywhere near that size. Just a round cover like a flush mounted tweeter, only a lot smaller. Would love to hear some suggestions.