ForOffRoadDriving
New Member
- Joined
- Aug 10, 2007
- Messages
- 2,715
- Reaction score
- 18
- Points
- 0
- Location
- HIGHLAND, MICHIGAN
- Vehicle Year
- 1994
- Make / Model
- FORD
- Engine Size
- 3.0L
- Transmission
- Manual
is there a way to bench bleed the clutch master cylinder like you can with a brake master cylinder or am i better off to wait until i have the trans back in the truck to fill it up and bleed it? it seems like if i fill the resevoir and push in the clutch push rod while its in the vise then its just going to get hard since no fluid can escape out of that quick disconnect end. oh yeah, its on a 1994 3.0l ranger with a m5od-r1.