ProTouringRanger
Member
- Joined
- Apr 3, 2018
- Messages
- 42
- Reaction score
- 7
- Points
- 8
- Location
- Alabama
- Vehicle Year
-
1991
2005
- Make / Model
- Ford
- Transmission
- Manual
Just started last year gathering parts and everyting else and still need more parts but iv got to start some where so here goes.
Motor 302 stroked out to 331,144ci blower, SFI billet bell housing, Tremec TECT 1377 Road Racing TKO ll , and 2 8.8 explorer rear ends.
Got the wheels in so i can get started on the Narrowing of the Rear (5 1/2") and the front too(1/2") to get the big wheels so they wont rub.
Pulled the stock motor and trans to get an idea on the sifter position and i have ordered a mid shift kit so the shifter will aligain back up .
The 302 block has a busted cylinder wall so i am using this as a mock up set up with nothing in the bell housing.
I have installed this 3 times, cut the fire wall out and might have to cut some more, and now have made motor mounts to position the motor back and down to help with weight.also center of gravity.
Motor 302 stroked out to 331,144ci blower, SFI billet bell housing, Tremec TECT 1377 Road Racing TKO ll , and 2 8.8 explorer rear ends.
Got the wheels in so i can get started on the Narrowing of the Rear (5 1/2") and the front too(1/2") to get the big wheels so they wont rub.
Pulled the stock motor and trans to get an idea on the sifter position and i have ordered a mid shift kit so the shifter will aligain back up .
The 302 block has a busted cylinder wall so i am using this as a mock up set up with nothing in the bell housing.
I have installed this 3 times, cut the fire wall out and might have to cut some more, and now have made motor mounts to position the motor back and down to help with weight.also center of gravity.
Attachments
-
300.3 KB Views: 790
-
291 KB Views: 800
-
322.6 KB Views: 749
-
311 KB Views: 750
-
227.5 KB Views: 752