raggedyann
New Member
- Joined
- Feb 20, 2013
- Messages
- 87
- Reaction score
- 1
- Points
- 0
- Vehicle Year
- 1998
- Make / Model
- ford
- Transmission
- Automatic
I just installed a Dana 35 in my 87 ranger,
At the end of axle shaft that comes thru the spindle, it had a splined washer and the c-clip.
Question, is this all goes here ?
my Dana 28 has a flat washer then a flat thrust needle bearing and then another washer , then c-clip.
I don't know if someone left these off or if the 35 doesn't use them.
it has Warn manual hubs.
At the end of axle shaft that comes thru the spindle, it had a splined washer and the c-clip.
Question, is this all goes here ?
my Dana 28 has a flat washer then a flat thrust needle bearing and then another washer , then c-clip.
I don't know if someone left these off or if the 35 doesn't use them.
it has Warn manual hubs.