- Joined
- Jul 30, 2011
- Messages
- 406
- Reaction score
- 2
- Points
- 0
- Location
- Austin tx
- Vehicle Year
- 1994
- Make / Model
- Ford
- Engine Size
- 5.0
- Transmission
- Automatic
- My credo
- Built not bought
Ok guys well I'm getting the wiring straighten out right now . So when I pulled the wiring from the expo I made sure to cut as much extra as I could which is enough to reach over to the stock ecu location on the driver side bulkhead . Svt was awesome enough to send me the 42 pin out for the expo harness but I need to find the info to connect it to my ranger harness for power and such and at what connectors to splice into . I labeled every wire on the 42 pin harness with tape so I don't have to keep looking at the chart Svt gave . I know there's like 4 harness connectors that ran to the 4.0 motor that I disconnected . I've been looking on alldata pro at work and haven't came across the diagram yet . A least if someone know what those connector numbers are I can look that up . Thanks guys
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk