7111127
New Member
- Joined
- Aug 22, 2009
- Messages
- 73
- Reaction score
- 0
- Points
- 0
- Age
- 34
- Location
- Coweta Oklahoma
- Vehicle Year
- 1984
- Make / Model
- Ford
- Engine Size
- 4.0
- Transmission
- Automatic
alright i am doing a swap from a 84 bronco ii changing all the stuff 2 a 95 ford explorer setup
i took the wiring harness and everything out of the bronco and put in the explorer stuff
there is a thing that the brake lines to went to that divides them on the bronco ii and had a wire plugged in to it on the explorer there aint one it had abs setup and i not takin the abs but am taking the brake master n shit wut do i gotta do 2 make it work can i just hook the lines in 2 off the master and not worry about the thing that divides them wires that was going 2 it?
i took the wiring harness and everything out of the bronco and put in the explorer stuff
there is a thing that the brake lines to went to that divides them on the bronco ii and had a wire plugged in to it on the explorer there aint one it had abs setup and i not takin the abs but am taking the brake master n shit wut do i gotta do 2 make it work can i just hook the lines in 2 off the master and not worry about the thing that divides them wires that was going 2 it?