UNIQUE OBSESSION
New Member
- Joined
- Feb 10, 2015
- Messages
- 8
- Reaction score
- 0
- Points
- 0
- Location
- Winchester, VA
- Vehicle Year
- 1997
- Make / Model
- Ford
- Engine Size
- 4.0L V6
- Transmission
- Automatic
Morning, I just did 4.88s in my 8.8 rear for my 97 Ranger. I bought the kit from James Oaks. The Locker is DET187C-147A. I have everything together and axles in but I can't get the pin in the center of the Locker. The Axles seem to be too close cause the pin hits the axles after the pin taper. The axles are seated in the locker and the c clips look seated also. Not sure what to do. Any advice is appreciated!