pita water pump

newbski · Dec 11, 2013

2.9 b2 are these darn things welded in. I have been trying to get the fan clutch deal off and my map gas torch and $12 air hammer with a 1gal air tank isn't getting me anywhere. Is there anything else I can try to get this off.

martin · Dec 12, 2013

Are you trying to turn it in the right direction? If it's driven by the face of the belt it's left hand thread. If its driven by the back of the belt it normal thread.

Beachbuggy · Dec 12, 2013

I've found an air hammer/chisel with a chisel tip works best, get on the edge of the nut and pull the trigger.

newbski · Dec 12, 2013

I know its reverse thread but ive been beating on this thing every witch way and it wont budge.

richard booth · Dec 19, 2013

There is a tool which consists of two wrenches, one that fits the nut and one that is much bigger that you hold on the nuts for the fan pulley. Most all cheap tool places carry a Ford fan removal set, spray some penetrating oil and use extensions and it will give up.

pita water pump

newbski

New Member

martin

New Member

Beachbuggy

New Member

newbski

New Member

richard booth

Member

Sponsored Ad

Sponsored Ad

Staff online

Members online

Member & Vendor Upgrades

Latest posts

Truck of The Month

Recently Featured

Follow TRS On Instagram

Latest Album Photos

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store

Sponsored Ad

Sponsored Ad

Sponsored Ad

Amazon Deals