bfrank
New Member
- Joined
- Dec 19, 2014
- Messages
- 2
- Reaction score
- 0
- Points
- 1
- Vehicle Year
- 1989
- Make / Model
- ford
- Transmission
- Manual
I just got a new slave cylinder from autozone for an 1989 ranger. it has a
'new and upgraded" fluid line fitting. Instead of the inner fingers that the male clutch line snaps into; it has a removable clip fitted into slots on the side. you push the line in until it snaps past the clip and that's what holds it in place. to remove the fluid line, you pull the clip and it comes right out. It all looks and sounds pretty good, but is it? does anyone have any experience with these fittings? I would appreciate some input before I go ahead and stab this tranny.
'new and upgraded" fluid line fitting. Instead of the inner fingers that the male clutch line snaps into; it has a removable clip fitted into slots on the side. you push the line in until it snaps past the clip and that's what holds it in place. to remove the fluid line, you pull the clip and it comes right out. It all looks and sounds pretty good, but is it? does anyone have any experience with these fittings? I would appreciate some input before I go ahead and stab this tranny.
Last edited: