Welcome Visitor! Please take a few seconds and 
adsm08
Senior Master Grease Monkey
Supporting Member
Article Contributor
Ford Technician
TRS 20th Anniversary
- Joined
- Sep 20, 2009
- Messages
- 34,623
- Reaction score
- 3,613
- Points
- 113
- Location
- Dillsburg PA
- Vehicle Year
- 1987
- Make / Model
- Ford
- Engine Type
- 4.0 V6
- Engine Size
- 4.0
- Transmission
- Manual
- 2WD / 4WD
- 4WD
- Tire Size
- 31X10.50X15
Ok guys. I'm at a bit of a loss here.
I need a name for my new build. I like my project names to reflect either the direction of the spirit of the build or the subject of the build.
Here is what I have so far:
A white and blue two-tone Bronco II.
Most of the work, at least initially will be body restoration. Not much rust, but lots of dings and dents, and three corners are pushed in good. Enough that none of the marker lights hang quite right and the lift gate is hard to get open.
The non-body work will mostly involve upgrading from the weaker versions of components (lose the auto hubs and repezza rear shaft, etc). I have a Ranger 8.8 with the right gears (needing swapped from my Expo axle) for the back, probably leave the D-28 for now.
Now, the wife will be doing a lot more work on this one than on Hillbilly Deluxe as this will be her winter beater for a while, and then ultimately my haul the kids around car when we have them.
I want to keep away from names involving color since we haven't decided if we are keeping the white-blue two-tone.
She is suggesting "Dirty Girl" since she will be helping so much. I was originally going to call it "Little Big Time" because the original plan was to bob a 3/4 ton frame and throw the body on that. Not doing that anymore.
So what are your ideas guys?
I need a name for my new build. I like my project names to reflect either the direction of the spirit of the build or the subject of the build.
Here is what I have so far:
A white and blue two-tone Bronco II.
Most of the work, at least initially will be body restoration. Not much rust, but lots of dings and dents, and three corners are pushed in good. Enough that none of the marker lights hang quite right and the lift gate is hard to get open.
The non-body work will mostly involve upgrading from the weaker versions of components (lose the auto hubs and repezza rear shaft, etc). I have a Ranger 8.8 with the right gears (needing swapped from my Expo axle) for the back, probably leave the D-28 for now.
Now, the wife will be doing a lot more work on this one than on Hillbilly Deluxe as this will be her winter beater for a while, and then ultimately my haul the kids around car when we have them.
I want to keep away from names involving color since we haven't decided if we are keeping the white-blue two-tone.
She is suggesting "Dirty Girl" since she will be helping so much. I was originally going to call it "Little Big Time" because the original plan was to bob a 3/4 ton frame and throw the body on that. Not doing that anymore.
So what are your ideas guys?
Last edited:
