doyouquaxu
New Member
I had a friend build a bumper for his truck, and after he got done he told me he got an extra set of frame horns cut out. So, I drove to his house and after a few days this is what I ended up with.
Frame horns. The three holes have 1.5" mild through them, and if I remember right (it was late when he told me) the plate is 3/16"
The next day, the top tube is 1 3/4". I know, the seam is on the outside. I'm not going to be hitting anything too hard, and if it bends.... its just a bumper.
This is the only real picture I have with the down tubes. We didn't have enough 1.5" tube, so they're 1 3/4". They go down, then we miter cut the tubes and then welded them to a tube that's welded to the leading edge of the XLT steering rack mount.
Skid plate. It bolts to the bumper in 6 spots, 4 on the front and 2 between the miter cut and the steering rack. There are 3 tabs on the top for lights. The light pictured is a 22" Vision X LED that I borrowed from him for the Barstow Clean Up on the 14th, but I got sick the 13th and didn't get to make it out.
Frame horns. The three holes have 1.5" mild through them, and if I remember right (it was late when he told me) the plate is 3/16"
The next day, the top tube is 1 3/4". I know, the seam is on the outside. I'm not going to be hitting anything too hard, and if it bends.... its just a bumper.
This is the only real picture I have with the down tubes. We didn't have enough 1.5" tube, so they're 1 3/4". They go down, then we miter cut the tubes and then welded them to a tube that's welded to the leading edge of the XLT steering rack mount.
Skid plate. It bolts to the bumper in 6 spots, 4 on the front and 2 between the miter cut and the steering rack. There are 3 tabs on the top for lights. The light pictured is a 22" Vision X LED that I borrowed from him for the Barstow Clean Up on the 14th, but I got sick the 13th and didn't get to make it out.