- Joined
- Aug 7, 2007
- Messages
- 1,733
- Reaction score
- 536
- Points
- 113
- Location
- Costa Mesa, CA
- Vehicle Year
- 2002
- Make / Model
- Ford
- Engine Type
- 4.0 V6
- Engine Size
- 4.0 SOHC
- Transmission
- Manual
- 2WD / 4WD
- 4WD
- Tire Size
- 33"
I am preparing to pull my transfer case and do at least a partial rebuild. My Ford repair manual indicates the rear output flange nut requires a torque of around 260 ft lbs. Is that correct or a typo? That seems to be very high. I don' have a torque wrench that goes that high.
It also states that the nut and washer are to be replaced. Apparently it is self locking and can only be used once.
It also states that the nut and washer are to be replaced. Apparently it is self locking and can only be used once.