QUICK QUESTION

[Bear in the woods]

Should the yolk on a transfer case for the front driveshaft ..should it be able to just slip right out or is there a problem

 

[snoranger]

That depends on the year and which t-case you have.

 

[85_Ranger4x4]

If it meets the t-case with a boot, yeah.

If the driveshaft telescopes in the middle (boot is in the middle of the driveshaft) no.

 

[Bear in the woods]

That depends on the year and which t-case you have.

Was on a 2003 5r55e

 

[snoranger]

On an ‘03 Tcase, you need to disassemble the case. The front output is held in by a snap ring.

 

[pjtoledo]

what he said.
the yoke/CV holder are one piece with the front output shaft.
they can be replaced with the older style front output shaft, disassembly required.

 

[don4331]

Time out: Why are you wanting to remove the yoke?

There are 6 Torx bolts holding the CV to the yoke. The driveshaft show go from CV to u-joint.

 

[Bear in the woods]

On an ‘03 Tcase, you need to disassemble the case. The front output is held in by a snap ring.

. Wrong picture of number. This one is correct