Welcome Visitor! Please take a few seconds and 
vaprobe87
New Member
- Joined
- May 25, 2013
- Messages
- 13
- Reaction score
- 0
- Points
- 1
- Location
- Nickelsville, VA
- Vehicle Year
- 2000
- Make / Model
- Ranger
- Engine Type
- 3.0 V6
- Engine Size
- 3.0L
- Transmission
- Manual
- 2WD / 4WD
- 4WD
I was wondering if the flanges where the y-pipe goes to the convertor is the same between a 3.0 and 4.0.
My dad has a 2003 4.0 Edge and his exhaust was rusted and broke off behind the convertors. I have a 2000 3.0 Ranger that's going to be parked for a while and was going to see if I could take the exhaust from the y-pipe back off my truck and put on his but didn't know if the flanges on the ends of the y-pipes are different.
My dad has a 2003 4.0 Edge and his exhaust was rusted and broke off behind the convertors. I have a 2000 3.0 Ranger that's going to be parked for a while and was going to see if I could take the exhaust from the y-pipe back off my truck and put on his but didn't know if the flanges on the ends of the y-pipes are different.
