• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

dana 35 torque spec


geoffthepoolguy

New Member
Joined
Jan 22, 2009
Messages
37
Reaction score
0
Points
0
Location
Clayton, NC
Vehicle Year
1990
Make / Model
Ford
Engine Size
2.9L V6
Transmission
Manual
anyone know the torque spec for the wheel bearing nut on a dana 35 axle? Also, do you torque it to spec and turn back 1/4 turn?

Thanks,

Geoff
 


CopyKat

New Member
Joined
Aug 18, 2007
Messages
2,274
Reaction score
8
Points
0
Location
Manitoba, Coldest place in Canada
Vehicle Year
1987
Make / Model
Ford
Engine Size
4.0L
Transmission
Manual
New bearings torque to about 30 inch/lb's while turning the rotor, this will seat them. Back off a full turn and tighten finger tight 15 in/lbs while turning the rotor again. Put the lock ring on and the outer night. Torque outer nut to 250 ft/lbs making sure the lock ring/inner nut doesn't turn.
 

Spowerback

Banned
--- Banned ---
Joined
Feb 16, 2010
Messages
429
Reaction score
0
Points
0
Location
California
Vehicle Year
2010
Make / Model
FORD
Engine Size
v6 4.0L /
Transmission
Automatic
torque spec for the wheel bearing nut on a dana 35 axle= finger tight wheel bearing same thing copykat
 
Last edited:

Sponsored Ad


Sponsored Ad

Members online

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Shran
April Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top