Wiring thru firewall

[1994xlt]

I wonder if I could run it thru the firewall without depining it if I go thru the clutch pedal now I just gotta figure out how to get to it

 

[Curious Hound]

I wonder if I could run it thru the firewall without depining it if I go thru the clutch pedal now I just gotta figure out how to get to it

You can. It just takes a bigger hole in the grommet and that would not be self-sealing.

The pins are held into the connector by tiny little barbs. To remove one, you have to squeeze the little barbs so the pin can be pulled back out. It usually takes a de-pinning tool, though with patience, you can do it with a tiny eye-glasses screwdriver. I believe that is a Molex connector. So it would take a Molex depinning tool.

 

[RobbieD]

I have no clue on how depin it I guess I’m gonna have to do this project another time I don’t know what I’m doing

Typically you just use an appropriate tool to push into the plastic connector to pry down a locking tab on the metal terminal. The tool has to fit without bending or breaking anything. In some cases you can use a small screwdriver, but in other cases you'll need a specialty tool made just for the task.

@Curious Hound does great how-to's; it'd be well worth it to wait and see if he can put something together.

Can you give us a clear pic of the mating end of that connector?

If it is a Molex, you'll need a special round de-pinning tool.

I wonder if I could run it thru the firewall without depining it if I go thru the clutch pedal now I just gotta figure out how to get to it

A metal plate covers the clutch hole. You could cut a slot in the metal, but you would still need to add a rubber grommet around the wire when you reinstall it.

 

[SenorNoob]

That looks just like the connectors on the chinese 4-wheelers I'm used to working on. If so the pins area very loose fit and can be removed with a bent paperclip.