will 33s fit with a 2in lift and 3in body

[91rangerstx]

ok so i have a 91 ranger stx 4x4 with a 3in body lift and 31s now and im thinking about buying this 2in lift kit off ebay its just spacers in front and a add a leaf in rear and i was wonding with that and the body lift thats on it if i could run 33s ??? anyone know thanks


heres a link to the lift http://cgi.ebay.com/ebaymotors/Ford...ryZ33585QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

 

[TrucksGetDirty]

33s will fit with just a 3inch body lift

 

[Sunk]

I'd get the Belltech 6400 shackles and F-150 spacers instead. That' should net you around 1.5-2" of lift.

http://www.therangerstation.com/Magazine/Summer2003/LiftingOnABudget.htm

http://www.therangerstation.com/tech_library/factoryspacer.htm

 

[Chris.S.]

The short answer is yes.

Hell you could probably 34's with the right backspacing.

 

[86ford]

33s will fit with just a 3inch body lift

wrong. 98 and up they will but not on the older ones unless you want to do some moderate trimming.i am currently running around a 3 inch suspension lift and have cut large amounts of fender to make my 33s fit. 2 inch coil spacers will more than likely throw your alignment (camber) out of spec. potentially to the point it cant be aligned.

86

 

[rickcdewitt]

your truck has a factory 2" lift.it depends on if you want a 9" lifted pile and no trimming or somewhere imbetween.you need to look at more peoples trucks to decide

 

[88mudder]

It will clear them on the streets but once you go wheeling you will rub alot.

 

[Big Red Ranger]

you can but you will need to trim a lot i got a 3in body and 2 in susp and i rub my 31 with no triming but yes it can be done

 

[Chris.S.]

The short answer is yes.

Hell you could probably 34's with the right backspacing.

I'm running 31.5's with just a 2" susp lift. I get very slight rubbing at full lock, either left or right it rubs the sway bar. No rubbing at all vertically, just on steering.

Ran into a guy last night who is running 33's with just the 2" susp lift, the body lift would gain the clearance neede vertically but you'll need to space the wheels out somewhat-probably 1" or maybe 1 1/2" by using wheel spacers or getting rims with less backset.

But I can only speak for trucks that are 07/08.

 

[Big Red Ranger]

http://www.therangerstation.com/tech_library/TireFitment.html

this will tell you