Transfercase swap.

[Wilcox]

Swapping out a touch electric transfercase to manual. Is there going to be any electrical problems doing this. I have manual hubs also. Any suggestions or issues i should be aware of before I start project? Thanks.

 

[Wilcox]

Swapping out a touch electric transfercase to manual. Is there going to be any electrical problems doing this. I have manual hubs also. Any suggestions or issues i should be aware of before I start project? Thanks.

Forgot to mention this is a 1988 ranger.

 

[Uncle Gump]

Not positive...

But if your manual linkage bolts to the tailshaft housing... not all of them will have provisions to do so.

For the electrical... I don't think there are issues. Speedo is cable. Pull the fuse... tape things up just in case you have to go back to electric... it will all still be there.

Also moved you to the transfer case forum...

 

[Wilcox]

I bought a 1988 doner truck with manual. Was going to use linkage and transfer out of it. Measured front and read drivelines both are the same length. Looks like a simple swap but just asking. Thanks.

 

[Curious Hound]

Electrically, no problem. The only issue I see is what Gump mentioned. The shifter linkage mounts to the transmission tailhousing. Your tailhousing may or may not have the threaded holes prepared for that. You may need to get tje tailhousing off the donor truck, if it's he same transnission. Or you may need to drill and tap the holes into the bosses molded onto the tailhousing. With both trucks being 88s, your chances are good that everything is ready for you. But no guarantee.