runnert
Active Member
1995 Ranger 4.0l 4x4
I went for an alignment yesterday and they said my tie rod to pitman was loose and that my tie rod to right knuckle was loose. They wanted almost $400 to do the job. Since I did my ball joints myself, I would do this job as well. I climbed under the front and I did all I could to prove those joints were loose. Sure I could rotate them down and up, but I could not see where they were loose. Or maybe I am not checking them correctly.
How do I tell if my tie rods are loose and need replaced? Or am I getting ripped off?
Thanks,
runnert
I went for an alignment yesterday and they said my tie rod to pitman was loose and that my tie rod to right knuckle was loose. They wanted almost $400 to do the job. Since I did my ball joints myself, I would do this job as well. I climbed under the front and I did all I could to prove those joints were loose. Sure I could rotate them down and up, but I could not see where they were loose. Or maybe I am not checking them correctly.
How do I tell if my tie rods are loose and need replaced? Or am I getting ripped off?
Thanks,
runnert