92ranger18
Well-Known Member
How could i make a sheet metal dash for my ranger? just a few gauges switches and a radio. i want it to look like a drag cars dash if you kno what i mean.
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Sheet metal dash?
- Thread starter 92ranger18
- Start date
the_intimidator03
Well-Known Member
- Joined
- Jul 15, 2012
- Messages
- 109
- Age
- 37
- City
- Roseburg. Oregon
- Vehicle Year
- 1989
- Engine
- 2.9 V6
- Transmission
- Manual
- Tire Size
- 235/75/15
they make trim to fit generic sheet metal dashes that would work great for ya. As far as getting these perhaps Speedway Motors may have them. It is also possible summit/jegs could carry them. there are other companies (my knowledge is circle track) such as Day motorsports, performance bodies etc.
AmericanPride
Well-Known Member
- Joined
- Sep 15, 2012
- Messages
- 81
- Vehicle Year
- 1999
- Transmission
- Manual
Find a local metal shop...probably cut you something out for cheap. Especially if they have a water jet
Dune Runner
Well-Known Member
Sheet metal brake, Some measurements and a couple of hours minimum. A half or quarter sheet of 3/64" should do ya.
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Latest posts
-
-
-
-
-
-
Wanted: Coil Spring Measurements When Installed (Stock & Lifted)
- Latest: Marcos_Rngr
-
-
-
-
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
