pismoduners
New Member
- Joined
- Apr 16, 2009
- Messages
- 4
- Vehicle Year
- 1989
- Transmission
- Manual
does anyone know how to and what fits, to put a power steering on a 1990 4 banger ranger. thank you
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
power steering
- Thread starter pismoduners
- Start date
- Joined
- Feb 28, 2001
- Messages
- 9,603
- City
- Dayton
- State - Country
- OR - USA
- Vehicle Year
- 1990, 1997
- Drive
- 4WD
- Engine
- 2.3 (4 Cylinder)
- Transmission
- Manual
- Total Lift
- 6
- Tire Size
- 35"
grab the pump with bracket, gearbox with pitman arm and the two hoses between them from a '89-91ish ranger 4 cylinder as they will have the same type of setup, any newer and you might have to grab most of the brackets for alternator and such
The purple one
Well-Known Member
Eat a power bar and be a man
. My 93 has no power steering works just fine. Sorry I could not help my self.
. My 93 has no power steering works just fine. Sorry I could not help my self.Duane867
Well-Known Member
same pulley with and belt type on an 89 though ?
- Joined
- Feb 28, 2001
- Messages
- 9,603
- City
- Dayton
- State - Country
- OR - USA
- Vehicle Year
- 1990, 1997
- Drive
- 4WD
- Engine
- 2.3 (4 Cylinder)
- Transmission
- Manual
- Total Lift
- 6
- Tire Size
- 35"
the front end of the years listed should be very similar, if you go to the junkyard and find an unmolested engine take all you can including the belt, there's not much to change, everything mounts off of the power steering pump bracket including the idler.
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
