adam17
Well-Known Member
im wanting to part and polish my heads and intake manifold. Has anyone done this? was it worth it, and what differences did you notice?
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
port and polish heads?
- Thread starter adam17
- Start date
machinehead
Member
This is a cheap way of improving flow. It is time consuming and if you make a mistake, good by heads.
The best way is to read the Tech Article here and find an old cylinder head to practice on BEFORE you trash yours.
A well done port and polish is good for spinning up. Easier revving and some Power gains. Add a free flow exhaust to complement the port and polish. You local muffler shop can do a better job and cheaper than a custom mail order exhaust.
The best way is to read the Tech Article here and find an old cylinder head to practice on BEFORE you trash yours.
A well done port and polish is good for spinning up. Easier revving and some Power gains. Add a free flow exhaust to complement the port and polish. You local muffler shop can do a better job and cheaper than a custom mail order exhaust.
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
