I have the tank installed, the electric fuel pump mounted, bypassed the original fuel pump and used a fuel filter to fill the gap. Ran some airline in a loop from inlet to outlet to protect the inside from outside grit and dust. I may use it again.
Getting the fuel fill back into place was a bit of a pain, the tank gasket I used was 1/4" smaller diameter than the old gasket and resisted being pulled out to the sheet metal. Got it finally...
I used my nutsert tool to place a couple 1/4" nuts for the fuel pump. It took me several minutes to figure out how to use it as it has been a very long time since I last used it.
Now I'm running wire up to the front for power to the pump. I think I will use a fused relay controled by oil pressure switch. Not quite sure what I'm doing so if anyone wants to chime in please do.
