no oil pressure

[red rocket]

ok got the motor to run and no oil presure go figure, thought that something was clogging the oil pick up tube, but doing somemore research on here i think i set up the lines for the remote oil filter kit wrong i hooked it up as from the motor inlet to inlet and outlet to outlet is this right or do i have to switch them. i threw away the destructions if anyone can helpthat would be greatly appreciated hope i didnt mess up the bearings

 

[The Weasel]

I hooked mine up as engine outlet to filter inlet and filter outlet to engine inlet.

 

[85_Ranger4x4]

I hooked mine up as engine outlet to filter inlet and filter outlet to engine inlet.

+1

What goes out(let) from the engine must be what goes in(let) to the filter housing. What comes out(let) from the filter housing must go in(let) to the engine.

 

[fordmike1]

Yep you got them backwards. Just like 85_Ranger4x4 said, Engine out to filter in and from filter out to engine in.

 

[red rocket]

yea did a freakin newbie mistake is all fixed now just get some oil and turn her over