My New House & Workshop

[Jim Oaks]

While I'm wating on my wire to arrive, I started installing all of the outlets and switches to the new wiring, and I needed to run some conduit down this wall to finish it. I painted the conduit, boxes, and covers white to go with the wall, and left the connectors and straps silver.

 

[Curious Hound]

While I'm wating on my wire to arrive, I started installing all of the outlets and switches to the new wiring, and I needed to run some conduit down this wall to finish it. I painted the conduit, boxes, and covers white to go with the wall, and left the connectors and straps silver.

View attachment 135246View attachment 135247​

Looks great, Jim. By the way, don't cut your wires too short. It's hard to see in the photo, so I don't know if you did or not. I'm hoping to be in "helpful hint" territory here. Cutting them short just makes life difficult for you, especially if you ever need to cut a bit off and reterminate a wire layer on. Code specifies 6" minimum. I believe that is 6" past the front face of the box, if I recall correctly. I don't particularly care about the exact measurement. The point is "don't make them so short that it's difficult or even irritating to strip, curl and connect them to the device (switch or outlet)." In tje big picture, 1 or 2 more inches on each pigtail really isn't a financial cost worth worrying about when you find out how "fun" it is working with short wires, especially when stretching over a countertop or kneeling next to an outlet at the bottom of a wall.

 

[bobbywalter]

first thing i was going to say, you want to layback for service.

wire management is always a bastard

 

[Jim Oaks]

 

[Curious Hound]

View attachment 135248
View attachment 135249​

Brautiful.

 

[Jim Oaks]

Hopefully I attached all the wires to the right places.

 

[Jim Oaks]

 

[sgtsandman]

 

[scotts90ranger]

Not that I have a personal issue with what you did but technically Romex isn't rated to be in conduit... it's also not rated to be exposed if I remember right too so not like I'm doing everything kosher in my shop

 

[Jim Oaks]

Not that I have a personal issue with what you did but technically Romex isn't rated to be in conduit... it's also not rated to be exposed if I remember right too so not like I'm doing everything kosher in my shop

The NEC allows non-metallic wires, such as Romex, to be run through conduits for protection.

However, there are precautions to consider, such as not using Romex outdoors or in wet or damp locations, and not exceeding the conduit fill requirement.