My 87 Ranger I will be restoring soon I want to keep track of my progress and add information as I find it.

[Terrys87]

@SenorNoob I made a run to the junkyard after work. From now on I will start getting any factory sensor I can find from the bone yard other than an O2 sensor. I will have a post below on that.

 

[Terrys87]

Went to the boneyard. I think I am just dealing with a faulty aftermarket sensor. I got the two water sensors and another throttle body. I will start getting sensors from the yards as I find them. I did find two badges, the clips that will hold my tonneau cover. Also got plugs to power to my air pumps for the seats. I will fab up a harness.

RockAuto is showing a 3 prong and 4 prong O2 sensor. I can see at least 3. I will have my son who can see better than me if there is a 4th prong. This is less then a year old but was unaware of the number of prongs. Could be part of my running rich issue.

This was a failure today. I was excited to start on getting my headliner ready to be installed in the next couple of days but it may just be a bad can. I will get another glue tomorrow and try again.

 

[Terrys87]

I will be going back to the boneyard soon. I found a black tube bumper, a great rear bumper that is chrome and a bed liner in a parts truck.

They have some 2.8. I hear the distributors are hard to find. They have some there. I can get them for cost and shipping or other small parts if needed. I found a truck with the tan tonneau cover I will be getting in the next trip to there.

They have a plentiful supply of 3rd gen trucks as well.

 

[rumblecloud]

...They have a plentiful supply of 3rd gen trucks as well.

That's about a 13 hour drive for me....3rd gens are getting rare around here.