2.3L ('83-'97) motor rebuild help short block

[2.3sandrail]

Hello
i have a 92 ranger with the 2.3 and i think i need to rebuild the motor. i have oil coming up the dipstick and getting all over the driver side of the engine compartment. and the more i drive it the worst it gets. i already have the head built with a aftermarket cam bigger valves.. so i am looking for a place to get a short block or a rebuild kit maybe looking for something 10 over... but i would really like a block that i can just bolt the head on and go .. thanks for your help

 

[alwaysFlOoReD]

Make sure the pcv system is working first.

 

[Josh B]

For reals! ^^^^^^^!

 

[2.3sandrail]

Make sure the pcv system is working first.

i did i checked the valve. i was told if you shack them and if it rattles then it is good.. i did not check the hose on either side did not feel a need to... is there any thing else to check or some other way of checking the pcv? thanks for your time

 

[alwaysFlOoReD]

Not an expert, but maybe pull hose from valve cover or wherever it gets connected to crankcase fumes. While running you should feel good suction.