LS swap! finally

[Mackhedq]

running better with fresh gas?

Much better. Took it around the block but it has a P2534 Ignition Switch Run/Start Position Circuit code. I cannot seem to clear it or figure out whats causing it for me. Truck is stuck in limp mode right now because of it.

 

[Mackhedq]

Found a dana 50 ttb and 10.25 for cheap....

 

[scotts90ranger]

You planning on making a Jana 54? It'd be the only way to outdo your D35 for travel, it's kinda crazy how cheap you can pick up D50 TTB's and 10.25's up for though... for $500 I have 3 10.25's, two D50's and a TTB D44 just waiting on me to get time to make a Jana 54 and swap that mess into the '00 Explorer...

 

[Mackhedq]

Well. Here it is.

My P2534 code was because my ECU AND TCM weren't turning on/off at the exact same time. I grounded a relay to the ECU on pin 59 black connector. Then used that to control TCM power.

 

[bobbywalter]

damn....that must have pissed ya off good and proper.....


she is awn now though....

 

[bobbywalter]

what cam?

 

[ryan]

Sounds very rowdy, makes me want to get mine done